Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Descrição
I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
Why are my consistent overhang issues getting worse? - General discussions - Bambu Lab Community Forum
BambuLab
Overhang Issues - General discussions - Bambu Lab Community Forum
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Overhang Issues - General discussions - Bambu Lab Community Forum
Poor overhang quality - Bambu Studio - Bambu Lab Community Forum
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Bambu Studio: How & WHY to use Support Overhang Shading. Also Orca! Bambu Lab P1P - P1S - X1C
Print Quality Issue, Overhangs, X1 Carbon, PLA - #22 by Rhotix - Bambu Studio - Bambu Lab Community Forum
AMS results for Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
de
por adulto (o preço varia de acordo com o tamanho do grupo)
