Nozzle problem : r/ender3
Descrição
which problem is this? The print looks smooth but somehow the walls are not sticking together. We tried slower printing, higher nozzle temperature and we checked the infill overlap (cura, set to
Nozzle sticking out too much after installing new hot end : r/ender3
Should fan duct be lower than nozzle? Ender 3 s1 : r/ender3
Help with nozzle lifting adjacent lines/surface issues : r/ender3
Ender 3 V2 Neo: The current hot bed and nozzle temperature is too low. : r/ ender3
After cleaning up a blob and removing nozzle, nozzle won't screw back in correctly. This is the max it goes, and it's not straight. Tried different nozzles and a lot of times.
What've I got set wrong? Ender-3 V2 Neo, .6mm nozzle. Just a spiral cube test print. : r/ender3
Nozzle is too Low Temperature Ender 3 V2 Pro : r/ender3
PETG problems, nozzle lifting up small corners. : r/ender3
Need help! Nozzle sink in the print cause E1 error. : r/ender3
Ender 3 S1 Pro Z issues - bad 1st layers, nozzle touching prints : r/ender3
Help! Ender 3 wont heat up. When I try to pre heat the nozzle, a clicking sound pops up and then I get this error message. Running on marlin software @ 4.2.7
Just got a bl touch. But now the nozzle won't reach the bed : r/ender3
Ender 3 Turmberg Titan Heatbreak Problems with underextrusion after some layers : r/ender3
Fixed some issues, still thinking my nozzle is trash? : r/ender3
de
por adulto (o preço varia de acordo com o tamanho do grupo)
